Siddhi Vinayak Trading Co.

One-component, acid-curing, silicone sealant forgeneral purpose sealing in do-it-yourself applications.WACKER GENERAL PURPOSE cures at roomtemperature under the action of atmospheric moistureto give a permanently flexible silicone rubber.Special characteristics• non-sag• ready to use at low (+5°C) and high (+40°C)temperatures• flexible at low (-50°C) and high temperatures(+150°C)• rapid crosslinking: quickly becomes tack-free• good adhesive strength to glass, vitrified surfaces,ceramic tiles, many plastics and most paints

single component moisture curing and self expanding aerosol polyurethane foam It is designed for easy dispensing through the straw adapter included with each can It does not contain any propellant gases that are harmful to the ozone layer Features amp Benefits Excellent adhesion amp filling capacity and high thermal amp acoustical insulation value Good for filling wide caps with its high expansion rate Economical consumption thanks to precise application High yield up to 45 liters depending on temperature and humidity Conforms to fire class B3 according to DIN 4102 1 Mould proof water proof and over paintable Applications Filling and sealing of especially wider gaps joints and cavities Fixing and insulating of door and window frames Filling of penetrations in walls Insulating electrical outlets and water pipes Instructions Optimal can temperature is 20 C Application ambient temperature is between 2 C to 30 C Shake the can well before use Screw the adapter on the valve Hold the can upside down and activate the foam by pressing the valve Moisturizing the surfaces and the foam improves adhesion and shortens curing time Fresh foam can be cleaned by Akfix Foam Cleaner Cured foam can be cleaned barely mechanically Standards Meets or exceeds the requirements of the following specifications The French VOC requirements for class A UL listed The requirements of VOC content specifications in LEED credit EQc4 1 Low emitting products of SCAQMD rule 1168 Restrictions Storage above 25 C and below 5 C shortens shelf life Should be stored and transported in vertical position Should be kept in room temperature for at least 12 hours before the application Cured foam will discolor if exposed to ultraviolet light Paint or coat the cured foam for best results in outdoor applications Safety Contains Diphenylmethane 4 4 Diisocyanate Harmful by inhalation Irritating to eyes respiratory system and skin Do not breathe spray vapour Wear suitable protective clothing and gloves Use only in well ventilated areas Pressurized container Keep away from direct sunlight and do not expose temperatures over 50 C Do not pierce or burn even after use Keep away from sources of ignition no smoking Keep out of the reach of children Storage and Shelf Life 15 months if stored properly